Dell PowerConnect B-FCXs Configuration Manual page 558

14
Displaying GVRP information
TABLE 82
This field...
GVRP Join Timer
GVRP Leave Timer
GVRP Leave-all Timer
Configuration that is being used
Spanning Tree
Dropped Packets Count
Number of VLANs in the GVRP
Database
Maximum Number of VLANs that
can be present
To display detailed GVRP information for an individual port, enter a command such as the following.
516
CLI display of summary GVRP information (Continued)
Displays...
The value of the Join timer.
NOTE: For descriptions of the Join, Leave, and Leaveall timers or to change the
timers, refer to
The value of the Leave timer.
The value of the Leaveall timer.
The configuration commands used to enable GVRP on individual ports. If GVRP
learning or advertising is disabled on a port, this information also is displayed.
The type of STP enabled on the device.
NOTE: The current release supports GVRP only with Single STP.
The number of GVRP packets that the device has dropped. A GVRP packet can
be dropped for either of the following reasons:
•
GVRP packets are received on a port on which GVRP is not enabled.
NOTE: If GVRP support is not globally enabled, the device does not drop the
GVRP packets but instead forwards them at Layer 2.
•
GVRP packets are received with an invalid GARP Protocol ID. The protocol
ID must always be 0x0001.
The number of VLANs in the GVRP database.
NOTE: This number includes the default VLAN (1), the GVRP base VLAN
(4093), and the single STP VLAN (4094). These VLANs are not
advertised by GVRP but are maintained as "Registration Forbidden".
The maximum number of VLANs that can be configured on the device. This
number includes statically configured VLANs, VLANs learned through GVRP,
and VLANs 1, 4093, and 4094.
To change the maximum number of VLANs the device can have, use the
system-max vlan <num> command. Refer to
parameter default settings"
"Changing the GVRP timers" on page 512.
"Displaying and modifying system
on page 321.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01