Dell PowerConnect B-FCXs Configuration Manual page 802

25
PIM Sparse
TABLE 137
This field...
RPT
SPT
Register Suppress
member ports
virtual ports
prune ports
virtual prune ports
760
Output of show ip pim mcache (Continued)
Displays...
Indicates whether the cache entry uses the RP path or the SPT path. The RPT flag can have
one of the following values:
•
0 – The SPT path is used instead of the RP path.
•
1– The RP path is used instead of the SPT path.
NOTE: The values of the RP and SPT flags are always opposite (one is set to 0 and the
other is set to 1).
Indicates whether the cache entry uses the RP path or the SPT path. The SP flag can have
one of the following values:
•
0 – The RP path is used instead of the SPT path.
•
1– The SPT path is used instead of the RP path.
NOTE: The values of the RP and SPT flags are always opposite (one is set to 0 and the
other is set to 1).
Indicates whether the Register Suppress timer is running. This field can have one of the
following values:
•
0 – The timer is not running.
•
1 – The timer is running.
Indicates the Layer 3 Switch physical ports to which the receivers for the source and group
are attached. The receivers can be directly attached or indirectly attached through other
PIM Sparse routers.
Indicates the virtual interfaces to which the receivers for the source and group are
attached. The receivers can be directly attached or indirectly attached through other PIM
Sparse routers.
Indicates the physical ports on which the Layer 3 Switch has received a prune notification
(in a Join/Prune message) to remove the receiver from the list of recipients for the group.
Indicates the virtual interfaces ports on which the Layer 3 Switch has received a prune
notification (in a Join/Prune message) to remove the receiver from the list of recipients for
the group.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01