Dell PowerConnect B-FCXs Configuration Manual page 944

27
Configuring MLD snooping
PowerConnect#show ipv6 mld-snooping mcache
Example: (S G) cnt=: (S G) are the lowest 32 bits, cnt: SW proc. count
vlan 1, has 2 cache
1
2
vlan 70, has 0 cache
Syntax: show ipv6 mld-snooping mcache
The following table describes the output from the ipv6 mld-snooping mcache command.
This field...
(abcd:ef50 0:100):
cnt
OIF
age
uptime
vidx
ref-cnt
Displaying software resource usage for VLANs
To display information about the software resources used, enter the following command.
PowerConnect#show ipv6 mld-snooping resource
mld group
mld phy port
snoop group hash
.... Entries deleted
total pool memory 194432 bytes
has total 1 forwarding hash
Available vidx: 4061
Syntax: show ipv6 mld-snooping resource
The following table describes the output from the show ipv6 mld-snooping resource command.
This field...
alloc
in-use
avail
902
OIF: 0/1/22 TR(0/1/32,0/1/33), TR is trunk, 0/1/32 primary, 0/1/33 output
(abcd:ef50 0:100), cnt=121
OIF: 0/1/11 0/1/9
age=0s up-time=120m vidx=4130 (ref-cnt=1)
(abcd:ef50 0:101), cnt=0
OIF: entire vlan
age=0s up-time=0m vidx=8191 (ref-cnt=1)
DIsplays...
The lowest 32 bits of source and group. It is displayed in XXXX:XXXX hex format. Here XXXX is
a 16-bit hex number.
The number of packets processed in software. IPv6 packets are switched in software,
causing this number to increase slowly.
Output interfaces. Entire vlan means that static groups apply to the entire VLAN.
The mcache age. The mcache is reset to 0 if traffic continues to arrive, otherwise it is aged
out when it reaches the time defined by ipv6 mld-snooping mcache-age.
The up time of this mcache in minutes.
The vidx is shared among mcaches using the same output interfaces. The vidx specifies the
output port list, which shows the index. Valid range is from 4096 to 8191.
The number of mcaches using this vidx.
alloc in-use
512
1024
512
Displays...
The allocated number of units.
The number of units which are currently used.
The number of available units.
avail get-fail
9 503 0
16 1008 0
9 503 0
PowerConnect B-Series FCX Configuration Guide
limit get-mem size init
32000 272 28
200000 279 21 1024
59392 272 20
53-1002266-01
256
256