Configuring Igmp Snooping - Dell PowerConnect B-FCXs Configuration Manual

Powerconnect b-series fcx
Hide thumbs Also See for PowerConnect B-FCXs:
Table of Contents

Advertisement

Notice that the ports connected to the source and the receivers are all in the same port-based
VLAN on the device. This is required for the PIM SM snooping feature. The devices on the edge of
the Global Ethernet cloud are configured for IP multicast traffic reduction and PIM SM traffic
snooping. Although this application uses multiple devices, the feature has the same requirements
and works the same way as it does on a single device.

Configuring IGMP snooping

To configure IGMP snooping on an PowerConnect B-Series FCX devices, you need to perform the
following global and VLAN-specific tasks.
Global tasks
Perform the following global tasks:
VLAN-specific tasks
Perform the following VLAN-specific tasks:
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
"Configuring the hardware and software resource limits"
"Enabling or disabling transmission and receipt of IGMP packets on a port"
"Configuring the global IGMP mode"
"Modifying the age interval"
"Modifying the query interval (active IGMP snooping mode only)"
"Configuring the global IGMP version"
"Configuring report control"
"Modifying the wait time before stopping traffic when receiving a leave message"
"Modifying the multicast cache age time"
"Enabling or disabling error and warning messages"
"Enabling or disabling PIM sparse snooping"
"Configuring the IGMP mode for a VLAN"
"Disabling IGMP snooping for the VLAN"
"Disabling PIM sparse mode snooping for the VLAN"
"Configuring the IGMP version for the VLAN"
"Configuring the IGMP version for individual ports"
"Configuring static groups to the entire VLAN or to specific ports"
"Configuring static router ports"
"Turning off static group proxy"
"Enabling IGMPv3 membership tracking and fast leave for the VLAN"
"Configuring fast leave for IGMPv2"
"Enabling fast convergence"
on page 656 (Must be enabled for IGMP snooping)
on page 657
on page 657
on page 657 (rate limiting)
on page 658
on page 658
on page 658
on page 659 (active or passive)
on page 659
on page 659
on page 660
on page 660
on page 661
on page 661
on page 662
on page 662
Configuring IGMP snooping
on page 656
on page 656
on page 657
on page 660
on page 661
22
on page 658
655

Advertisement

Table of Contents
loading

Table of Contents