Modifying System Parameter Default Values - Dell PowerConnect B-FCXs Configuration Manual

TABLE 58
This system parameter...
hw-ip-mcast-mll
hw-ip-next-hop
hw-logical-interface
hw-traffic-conditioner
ip-arp
ip-cache
ip-filter-port
ip-filter-sys
ip-qos-session
ip-route
ip-static-arp
ip-static-route
ip-subnet-port
l3-vlan
mac
mac-filter-port
mac-filter-sys
multicast-route
pim-mcache
rmon-entries
session-limit
spanning-tree
view
virtual-interface
vlan
mld-max-group-addr
igmp-snoop-mcache
mld-snoop-mcache

Modifying system parameter default values

Information for the configurable tables appears under the columns that are shown in bold type in
the above examples. To simplify configuration, the command parameter you enter to configure the
table is used for the table name. For example, to increase the capacity of the IP route table, enter
the following commands.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Displaying and modifying system parameter default settings
System parameters in show default values command (Continued)
Defines the maximum number of...
Multicast output interfaces (clients)
IP next hops and routes, including unicast next hops and multicast route
entries
Hardware logical interface pairs (physical port and VLAN pairs)
Traffic policies
ARP entries
IP forwarding cache entries
IP ACL entries per port
IP ACL entries per system
Layer 4 session table entries
Learned IP routes
Static IP ARP entries
Static IP routes
IP subnets per port
Layer 3 VLANs
MAC entries
MAC address filter entries per port
MAC address filter entries per system
Multicast routes
PIM multicast cache entries
RMON control table entries
Session entries
Spanning tree instances
SNMP views
Virtual routing interfaces
VLANs
MLD group limit
IGMP snooping cache entries
MLD snooping cache entries
9
325