Dell PowerConnect B-FCXs Configuration Manual page 177

S8:M2 FCX-1XG 1-port 16G Module (1-XFP)
S8:M3 FCX-1XG 1-port 16G Module (1-XFP)
PowerConnect(config)#
Syntax: show module
Table 27
TABLE 27
This field...
Module
Status
Ports
Starting MAC
Displaying stack resource information
Use the show stack resource command to display stack resource information, as shown in this
example.
PowerConnect# show stack resource
register attribute
general 12B data
RB-tree node
PowerConnect#
Syntax: show stack resource
Table 28
TABLE 28
This field...
This command displays the following information for register attributes, general 12B data, and RB-tree node
alloc
in-use
avail
get-fail
limit
get-mem
size
init
Displaying stack information
You can display information about any and all of the members in an IronStack by entering show
commands from the Active Controller console port. If you enter show commands from a unit that is
not the Active Controller, the information may not be displayed correctly.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
describes the fields displayed in this output example.
Field definitions for the show module command
Describes...
Identifies the module, by stack unit ID, module number, module type
The status of this module
The number of ports in this module
The starting MAC address for this module
alloc in-use
2400
32
4096
describes the output fields for this command.
Field definitions for the show stack resource command
Describes...
Memory allocated
Memory in use
Available memory
The number of get requests that have failed.
The maximum memory allocation
The number of get-memory requests
The size
The number of requests initiated.
Managing your IronStack
avail get-fail
2347 53 0
8 24 0
2347 1749 0
OK 1 0012.f2eb.d570
OK 1 0012.f2eb.d571
limit get-mem size init
556800 3089 142 2400
7424 8 12
237568 2702 18 1024
5
32
135