Displaying System-Wide Vlan Information - Dell PowerConnect B-FCXs Configuration Manual

Displaying system-wide VLAN information

Use the show vlans command to display VLAN information for all the VLANs configured on the
device.
The following example shows the display for the IP subnet and IPX network VLANs configured in the
examples in
IPX network VLAN with dynamic ports"
PowerConnect# show vlans
Total PORT-VLAN entries: 2
Maximum PORT-VLAN entries: 8
legend: [S=Slot]
PORT-VLAN 1, Name DEFAULT-VLAN, Priority level0, Spanning tree Off
Untagged Ports: (S2)
Untagged Ports: (S2) 17 18 19 20 21 22 23 24
Untagged Ports: (S4)
Untagged Ports: (S4) 17 18 19 20 21 22 23 24
Tagged Ports: None
PORT-VLAN 10, Name IP_VLAN, Priority level0, Spanning tree Off
Untagged Ports: (S1)
Tagged Ports: None
IP-subnet VLAN 1.1.1.0 255.255.255.0, Dynamic port enabled
Static ports: None
Exclude ports: None
Dynamic ports: (S1)
PORT-VLAN 20, Name IPX_VLAN, Priority level0, Spanning tree Off
Untagged Ports: (S2)
Tagged Ports: None
IPX-network VLAN 0000ABCD, frame type ethernet_ii, Dynamic port enabled
Static ports: None
Exclude ports: None
Dynamic ports: (S2)
In the show vlans output, ports that are tagged but are not dual-mode ports are listed as tagged
ports. In the following example display output, ports 7 and 8 are dual-mode ports in port-based
VLAN 4. Ports 7 and 8 also belong to port-based VLAN 3, but they are tagged ports only in VLAN 3
and are not configured as dual-mode ports.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
"Configuring an IP subnet VLAN with dynamic ports"
1 2 3
1 2 3
1 2 3
Name: Mktg-LAN
1 2 3
1 2 3
Name: Eng-LAN
1 2 3
Displaying VLAN information
on page 467.
4 5 6 7 8 9 10 11 12 13 14 15 16
4 5 6 7 8 9 10 11 12 13 14 15 16
4 5 6
4 5 6
4 5 6
4 5 6
on page 466 and "Configuring an
13
501