Assigning Trunk Group Ports; Configuring Port-Based Vlans - Dell PowerConnect B-FCXs Configuration Manual

13
Routing between VLANs
TABLE 77
This field
Re-assign
Current
1.

Assigning trunk group ports

When a "lead" trunk group port is assigned to a VLAN, all other members of the trunk group are
automatically added to that VLAN. A lead port is the first port of a trunk group port range; for
example, "1" in 1 – 4 or "5" in
5 – 8. Refer to

Configuring port-based VLANs

Port-based VLANs allow you to provide separate spanning tree protocol (STP) domains or broadcast
domains on a port-by-port basis.
This section describes how to perform the following tasks for port-based VLANs using the CLI:
•
•
•
•
•
Example 1
Figure 94
within each VLAN are untagged. One untagged port within each VLAN is used to connect the Layer
2 Switch to a Layer 3 Switch for Layer 3 connectivity between the two port-based VLANs.
446
Output of the show reserved-vlan-map command (Continued)
If you reassign a reserved VLAN without saving the configuration and
reloading the software, the reassigned VLAN ID will display in the
Re-assign column. However, the previously configured or default VLAN
ID will display in the Current column until the configuration is saved and
the device reloaded.
"Trunk group rules"
Create a VLAN
Delete a VLAN
Modify a VLAN
Change a VLAN priority
Enable or disable STP on the VLAN
shows a simple port-based VLAN configuration using a single Layer 2 Switch. All ports
Displays
The VLAN ID to which the reserved VLAN was reassigned.
The current VLAN ID for the reserved VLAN.
on page 395 for more information.
PowerConnect B-Series FCX Configuration Guide
1
1
53-1002266-01