Displaying Bsr Information - Dell PowerConnect B-FCXs Configuration Manual

25
PIM Sparse
PowerConnect#show ip pim group
Total number of Groups: 2
Index 1
Syntax: show ip pim group
This display shows the following information.
TABLE 128
This field...
Total number of Groups
Index
Group
Ports

Displaying BSR information

To display BSR information, enter the following command at any CLI level.
PowerConnect#show ip pim bsr
PIMv2 Bootstrap information
This system is the elected Bootstrap Router (BSR)
BSR address: 207.95.7.1
Uptime: 00:33:52, BSR priority: 5, Hash mask length: 32
Next bootstrap message in 00:00:20
Next Candidate-RP-advertisement in 00:00:10
RP: 207.95.7.1
Candidate-RP-advertisement period: 60
This example show information displayed on a Layer 3 Switch that has been elected as the BSR.
The following example shows information displayed on a Layer 3 Switch that is not the BSR. Notice
that some fields shown in the example above do not appear in the example below.
PowerConnect#show ip pim bsr
PIMv2 Bootstrap information
local BSR address = 207.95.7.1
local BSR priority = 5
Syntax: show ip pim bsr
This display shows the following information.
752
Group 239.255.162.1
Output of show ip pim group
Displays...
Lists the total number of IP multicast groups the Layer 3 Switch is forwarding.
NOTE: This list can include groups that are not PIM Sparse groups. If interfaces on
The index number of the table entry in the display.
The multicast group address
The Layer 3 Switch ports connected to the receivers of the groups.
group prefixes:
224.0.0.0 / 4
Ports e3/11
the Layer 3 Switch are configured for regular PIM (dense mode) or DVMRP,
these groups are listed too.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01