Mib Support; Syslog Messages; Configuring Lldp - Dell PowerConnect B-FCXs Configuration Manual

24

MIB support

FIGURE 119
MIB support
Dell PowerConnect devices support the following standard MIB modules:
•
•
•
•

Syslog messages

Syslog messages for LLDP provide management applications with information related to MIB data
consistency and general status. These Syslog messages correspond to the lldpRemTablesChange
SNMP notifications. Refer to
page 697.
Syslog messages for LLDP-MED provide management applications with information related to
topology changes. These Syslog messages correspond to the lldpXMedTopologyChangeDetected
SNMP notifications. Refer to
topology changes"

Configuring LLDP

This section describes how to enable and configure LLDP.
Table 123
TABLE 123
Global task
Enabling LLDP on a global basis
Specifying the maximum number of LLDP
neighbors per device
Specifying the maximum number of LLDP
neighbors per port
Enabling SNMP notifications and Syslog messages
Changing the minimum time between SNMP traps
and Syslog messages
692
TTL TLV packet format
TLV Type = 3
7 bits
LLDP-MIB
LLDP-EXT-DOT1-MIB
LLDP-EXT-DOT3-MIB
LLDP-EXT-MED-MIB
"Enabling LLDP SNMP notifications and syslog messages"
"Enabling SNMP notifications and syslog messages for LLDP-MED
on page 708.
lists the LLDP global-level tasks and the default behavior/value for each task.
LLDP global configuration tasks and default behavior /value
TLV Information
Time to Live (TTL)
String Length = 2
9 bits 2 octets
Default behavior / value when LLDP is enabled
Disabled
Automatically set to 392 neighbors per device
Automatically set to 4 neighbors per port
Disabled
Automatically set to 2 seconds when SNMP notifications and
Syslog messages for LLDP are enabled
PowerConnect B-Series FCX Configuration Guide
on
53-1002266-01