Acl-Based Inbound Mirroring; Series Fcx Devices; Mac Address Filter-Based Mirroring; Configuring Mac Address Filter-Based Mirroring - Dell PowerConnect B-FCXs Configuration Manual

20

ACL-based inbound mirroring

ACL-based inbound mirroring
This section describes ACL-based inbound mirroring for PowerConnect devices.
Creating an ACL-based inbound mirror clause for PowerConnect
B-Series FCX devices
The following example shows how to configure an ACL-based inbound mirror clause.
1. Configure the mirror port.
2. Configure the ACL inbound mirror clause.
3. Apply the ACL inbound clause to the monitor port.
4. Create the ACL mirror port.
To display ACL mirror settings, enter the show access-list all command.
The configuration process is now complete.

MAC address filter-based mirroring

This feature allows traffic entering an ingress port to be monitored from a mirror port connected to
a data analyzer, based on specific source and destination MAC addresses. This feature supports
mirroring of inbound traffic only. Outbound mirroring is not supported.
MAC-Filter-Based Mirroring allows a user to specify a particular stream of data for mirroring using a
filter. This eliminates the need to analyze all incoming data to the monitored port. To configure
MAC-Filter-Based Mirroring, the user must perform three steps:
•
•
•
The following sections describe these steps.

Configuring MAC address filter-based mirroring

Follow the steps below to configure MAC address filter-based mirroring.
638
PowerConnect(config)#mirror-port ethernet 1/1/2
PowerConnect(config)#access-list 101 permit ip any any mirror
PowerConnect(config)#int e 1/1/5
PowerConnect(config-if-e1000-1/1/5)#ip access-group 101 in
PowerConnect(config-if-e1000-1/1/5)#acl-mirror-port ethernet 1/1/2
PowerConnect#show access-list all
Extended IP access list 101
permit ip any any mirror
Define a mirror port
Create a MAC address filter with a mirroring clause
Apply the MAC address filter to an interface
PowerConnect B-Series FCX Configuration Guide
53-1002266-01