Dell PowerConnect B-FCXs Configuration Manual page 709

Field
GSQry
Mbr
MbrV2
MbrV3
IsIN
IsEX
ToIN
ToEX
ALLO
BLK
Pkt-Err
Pimsm-snooping hello, join,
prune
Displaying IGMP snooping information by VLAN
You can display IGMP snooping information for all VLANs or for a specific VLAN. For example, to
display IGMP snooping information for VLAN 70, enter the following command.
PowerConnect# show ip multicast vlan 70
version=2, query-t=30, group-aging-t=140, max-resp-t=3, other-qr-present-t=63
VL70: dft V2, vlan cfg passive, , pimsm (vlan cfg), track, 0 grp, 1 (*G) cache,
rtr ports,
0/1/13
0/1/14
0/1/20
Syntax: show ip multicast vlan [<vlan-id>]
If you do not specify a <vlan-id>, information for all VLANs is displayed.
The following table describes the information displayed by the show ip multicast vlan command.
Field
version
query-t
group-aging-t
rtr-port
max-resp-t
non-QR
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Description
Number of group source-specific queries received or sent.
The membership report.
The IGMPv2 membership report.
The IGMPv3 membership report.
Number of source addresses that were included in the traffic.
Number of source addresses that were excluded in the traffic.
Number of times the interface mode changed from EXCLUDE to INCLUDE.
Number of times the interface mode changed from INCLUDE to EXCLUDE.
Number of times that additional source addresses were allowed on the interface.
Number of times that sources were removed from an interface.
Number of packets having errors, such as checksum.
Number of PIM sparse hello, join, and prune packets
router ports: 0/1/13(140) 1.1.70.3, 0/1/20(180) 1.1.70.2, 0/1/14(180)
has 0 groups, non-QR (passive), default V2
has 0 groups, non-QR (passive), default V2
has 0 groups, non-QR (passive), default V2
Description
The IGMP version number
How often a querier sends a general query on the interface.
The number of seconds membership groups can be members of this group before aging out.
The router ports which are the ports receiving queries. The display router ports:
0/1/13(140) 1.1.70.3 means port 0/1/13 has a querier with 1.1.70.3 address, and a
remaining life of 140 seconds.
The maximum number of seconds a client waits before it replies to the query.
Indicates that the port is a non-querier.
Displaying IGMP snooping information
22
667