Displaying Lacp Status Information - Dell PowerConnect B-FCXs Configuration Manual

12
Displaying and determining the status of aggregate links
TABLE 75
This field...
Def
Exp
Ope
Displaying link aggregation and port status information for PowerConnect
Stackable devices
To display link aggregation information for devices in an IronStack, enter the show link-aggregate
command. The output for an Ironstack resembles the following.
PowerConnect(config)#show link-aggregate
System ID: 0012.f2e5.a200
Long timeout: 120, default: 120
Short timeout: 3, default: 3
Port [Sys P] [Port P] [ Key ] [Act][Tio][Agg][Syn][Col][Dis][Def][Exp][Ope]
1/1/1 1
2/1/1 1
3/1/1 1
4/1/1 1

Displaying LACP status information

Use the show trunk command to determine the status of LACP. Refer to
configuration information"
424
CLI display of link aggregation information (Continued)
Displays...
Indicates whether the port is using default link aggregation values. The port uses default values
if it has not received link aggregation information through LACP from the port at the remote end
of the link. This field can have one of the following values:
•
Def – The port has not received link aggregation values from the port at the other end of the
link and is therefore using its default link aggregation LACP settings.
•
No – The port has received link aggregation information from the port at the other end of
the link and is using the settings negotiated with that port.
Indicates whether the negotiated link aggregation settings have expired. The settings expire if
the port does not receive an LACPDU message from the port at the other end of the link before
the message timer expires. This field can have one of the following values:
•
Exp – The link aggregation settings this port negotiated with the port at the other end of the
link have expired. The port is now using its default link aggregation settings.
•
No – The link aggregation values that this port negotiated with the port at the other end of
the link have not expired, so the port is still using the negotiated settings.
•
Ope (operational) - The port is operating normally.
•
Ina (inactive) - The port is inactive because the port on the other side of the link is down or
has stopped transmitting LACP packets.
•
Blo (blocked) - The port is blocked because the adjacent port is not configured with link
aggregation or because it is not able to join a trunk group. To unblock the port and bring it to
an operational state, enable link aggregation on the adjacent port and ensure that the ports
have the same key.
1 13000 Yes
1 13000 Yes
1 13000 Yes
1 13000 Yes
on page 408.
L Agg Syn Col Dis
L Agg Syn Col Dis
L Agg Syn Col Dis
L Agg Syn Col Dis
PowerConnect B-Series FCX Configuration Guide
No No Ope
No No Ope
No No Ope
No No Ope
"Displaying trunk group
53-1002266-01