Dell PowerConnect B-FCXs Configuration Manual page 888

26
Configuring IP parameters – Layer 3 Switches
TABLE 153
Command
ip dhcp-server arp-ping-timeout <#>
clear ip dhcp-server binding
ip dhcp-server enable
no ip dhcp-server mgmt
ip dhcp-server pool <name>
ip dhcp-server relay-agent-echo
enable
ip dhcp-server <server-id> <address>
show ip dhcp-server binding
[<address>]
show ip dhcp-server address-pool
<name>
show ip dhcp-server flash
show ip dhcp-server summary
bootfile <name>
deploy
dhcp-default-router <addresses>
dns-server <addresses>
domain-name <domain>
lease <days><hours><minutes>
excluded-address [<address>
|<address-low> | <address-high>]
846
DHCP Server CLI commands
Description
Specifies the time (in seconds) the server will wait for a response to an
arp-ping packet before deleting the client from the binding database. The
minimum setting is 5 seconds and the maximum time is 30 seconds.
NOTE: Do not alter the default value unless it is necessary. Increasing
Deletes a specific, or all leases from the binding database. Refer to
"Removing DHCP leases"
Enables the DHCP server feature. Refer to
page 847.
Disables DHCP server on the management port. Refer to
Server on the management port"
Switches to pool configuration mode (config-dhcp-name# prompt) and
creates an address pool. Refer to
page 848.
Enables relay agent echo (Option 82). Refer to
(Option 82)"
Specifies the IP address of the selected DHCP server. Refer to
"Configuring the IP address of the DHCP server"
Displays a specific lease entry, or all lease entries. Refer to
lease entries"
Displays a specific address pool or all address pools. Refer to
address-pool information"
Displays the lease binding database that is stored in flash memory. Refer
to "Display lease-binding information in flash memory"
Displays a summary of active leases, deployed address pools,
undeployed address pools, and server
server information"
Specifies a boot image to be used by the client. Refer to
boot image"
Deploys an address pool configuration to the server. Refer to
address pool configuration to the server"
Specifies the IP address of the default router or routers for a client. Refer
to "Specify default routers available to the client"
Specifies the IP addresses of a DNS server or servers available to the
client. Refer to
Configures the domain name for the client. Refer to
domain name for the client"
Specifies the lease duration for an address pool. The default is a one-day
lease. Refer
page 849.
Specifies an address or range of addresses to be excluded from the
address pool. Refer
pool"
the value of this timer may increase the time to get console
access after a reboot.
on page 847.
on page 847.
"Creating an address pool"
on page 848.
on page 851.
on page 851.
on page 853.
on page 849.
"Specify DNS servers available to the client"
on page 849.
to"Configure the lease duration for the address pool"
to"Specify addresses to exclude from the address
on page 850.
PowerConnect B-Series FCX Configuration Guide
"Enabling DHCP Server" on
"Disabling DHCP
on
"Enabling relay agent echo
on page 848.
"Display active
"Display
on page 852.
uptime."Display summary DHCP
"Configure the
"Deploy an
on page 849.
on page 849.
on page 849.
"Configure the
on
53-1002266-01