Displaying Ip Interface Information - Dell PowerConnect B-FCXs Configuration Manual

Powerconnect b-series fcx

Hide thumbs Also See for PowerConnect B-FCXs:

Table of Contents

To display utilization statistics for a specific number of seconds, enter a command such as the

PowerConnect# show process cpu 2

Statistics for last 1 sec and 80 ms

Process Name

When you specify how many seconds' worth of statistics you want to display, the software selects

the sample that most closely matches the number of seconds you specified. In this example,

statistics are requested for the previous two seconds. The closest sample available is actually for

the previous 1 second plus 80 milliseconds.

Syntax: show process cpu [<num>]

The <num> parameter specifies the number of seconds and can be from 1 through 900. If you use

this parameter, the command lists the usage statistics only for the specified number of seconds. If

you do not use this parameter, the command lists the usage statistics for the previous one-second,

one-minute, five-minute, and fifteen-minute intervals.

Displaying IP interface information

To display IP interface information, enter the following command at any CLI level.

PowerConnect# show ip interface

Ethernet 1/1

Ethernet 1/2

Syntax: show ip interface [ethernet [<slotnum>/]<portnum>] | [loopback <num>] | [ve <num>]

This display shows the following information.

This field...

PowerConnect B-Series FCX Configuration Guide

53-1002266-01

Displaying IP configuration information and statistics

207.95.6.173

CLI display of interface IP configuration information

The type and the slot and port number of the interface.

The IP address of the interface.

NOTE: If an "s" is listed following the address, this is a secondary address. When the address

was configured, the interface already had an IP address in the same subnet, so the

software required the "secondary" option before the software could add the interface.

Whether the IP address has been configured on the interface.