Image File Types; Viewing The Contents Of Flash Files - Dell PowerConnect B-FCXs Configuration Manual

Image file types

This section lists the boot and flash image file types supported and how to install them on the
PowerConnect family of switches. For information about a specific version of code, refer to the
release notes.
TABLE 13
Product
PowerConnect B-Series FCX
1.

Viewing the contents of flash files

The copy flash console command can be used to display the contents of a configuration file,
backup file, or renamed file stored in flash memory. The file contents are displayed on the console
when the command is entered at the CLI.
To display a list of files stored in flash memory, do one of the following:
•
The following shows an example command output.
PowerConnect#show dir
133 [38f4] boot-parameter
3802772 [0000] primary
4867691 [0000] secondary
8674340 bytes 7 File(s)
56492032 bytes free
Syntax: show dir
To display the contents of a flash configuration file, enter a command such as the following from
the User EXEC or Privileged EXEC mode of the CLI:
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Software image files
For PowerConnect B-Series FCX devices, enter the show dir command at any level of the CLI, or
enter the dir command at the boot-monitor mode.
0 [ffff] bootrom
163 [dd8e] stacking.boot
1773 [0d2d] startup-config
1808 [acfa] startup-config.backup
1
Boot image
GRZxxxxxx.bin
Image file types
Flash image
FCXSxxxxx.bin (Layer 2) or
FCXRxxxxx.bin (Layer 3)
3
61