Displaying Ironstack Information - Dell PowerConnect B-FCXs Configuration Manual

•
•
NOTE
The stack unconfigure me command is available to all units, while stack unconfigure all and stack
unconfigure <stack-unit> are available on the Active Controller only.
The following example shows a session where stack unit 2 is unconfigured.
PowerConnect# show stack
alone: standalone, D: dynamic config, S: static config
ID
1 S
2 S
3 S
PowerConnect# stack unconfigure 2
Will recover pre-stacking startup config of this unit, and reset it. Are you sure?
(enter 'y' or 'n'): y
Stack 2 deletes stack bootup flash and recover startup-config.txt from .old
PowerConnect# show stack
alone: standalone, D: dynamic config, S: static config
ID
1 S
2 S
3 S
When the stack unconfigure 2 command is issued, stack unit 2 recovers the startup-config.txt from
the startup-config.old configuration file that was saved when this unit downloaded its configuration
from the Active Controller. As the output shows, stack member 2 has been removed from the stack,
and ID 2 is now is reserved for a replacement unit. Stack member 3 is now the Standby Controller.

Displaying IronStack information

This section describes the show commands for an IronStack, including output examples and field
descriptions.
Displaying flash information
Use the show flash command to display flash memory information for all members of a stack, or for
a specified stack member.
Syntax: show flash <stack-unit>
Output from the show flash command for a stack resembles the following (for a stack with three
members).
From the Active Controller for the entire stack:
PowerConnect# show flash
Stack unit 1:
Compressed Pri Code size = 3034232, Version 05.0.00T7e1 (FCX05000.bin)
Compressed Sec Code size = 2873568, Version 04.2.00T7e1 (FCX04200.bin)
Compressed BootROM Code size = 405217, Version 04.0.00T7e5
Code Flash Free Space = 2146304
Stack unit 2:
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
me - unconfigure this unit only
clean - removes all startup configuration files including v4 and v5 and makes this a clean unit
Type Role Mac Address
FCX624 active 0012.f2eb.a900 128 local
FCX648 standby 00f0.424f.4243
FCX624 member 00e0.5201.0100
Type Role Mac Address
FCX624 active 0012.f2eb.a900 128 local
FCX648 member 0000.0000.0000
FCX624 standby 00e0.5201.0100
Managing your IronStack
Pri State Comment
Ready
0 remote Ready
0 remote Ready
Pri State Comment
Ready
0 reserved
0 remote Ready
5
131