Dell PowerConnect B-FCXs Configuration Manual page 66

Powerconnect b-series fcx
Hide thumbs Also See for PowerConnect B-FCXs:
Table of Contents

Advertisement

2
Configuring basic system parameters
NOTE
Dell PowerConnect devices do not retain time and date information across power cycles. Unless you
want to reconfigure the system time counter each time the system is reset, Dell PowerConnect
recommends that you use the SNTP feature.
To identify an SNTP server with IP address 208.99.8.95 to act as the clock reference for a Dell
PowerConnect device, enter the following.
PowerConnect(config)# sntp server 208.99.8.95
Syntax: sntp server <ip-addr> | <hostname> [<version>]
The <version> parameter specifies the SNTP version the server is running and can be from 1 – 4.
The default is 1. You can configure up to three SNTP servers by entering three separate sntp server
commands.
By default, the Dell PowerConnect device polls its SNTP server every 30 minutes (1800 seconds).
To configure the Dell PowerConnect device to poll for clock updates from a SNTP server every 15
minutes, enter the following.
PowerConnect(config)# sntp poll-interval 900
Syntax: [no] sntp poll-interval <1-65535>
To display information about SNTP associations, enter the following command.
PowerConnect# show sntp associations
address
~207.95.6.102
~207.95.6.101
* synced, ~ configured
Syntax: show sntp associations
The following table describes the information displayed by the show sntp associations command.
TABLE 7
This field...
(leading character)
address
ref clock
st
when
poll
delay
disp
To display information about SNTP status, enter the following command.
24
ref clock
0.0.0.0
0.0.0.0
Output from the show sntp associations command
Displays...
One or both of the following:
*
~
IP address of the peer
IP address of the peer reference clock
NTP stratum level of the peer
Amount of time since the last NTP packet was received from the peer
Poll interval in seconds
Round trip delay in milliseconds
Dispersion in seconds
st
when
poll
delay
16
202
4
0.0
16
202
0
0.0
Synchronized to this peer
Peer is statically configured
PowerConnect B-Series FCX Configuration Guide
disp
5.45
0.0
53-1002266-01

Advertisement

Table of Contents
loading

Table of Contents