Configuring Fip Snooping; Displaying Fip Snooping Information - Dell S4820T Configuration Manual

Configuring FIP Snooping

You can enable FIP snooping globally on all FCoE VLANs on a switch or on an individual FCoE VLAN.
By default, FIP snooping is disabled.
To enable FCoE transit on the switch and configure the FCoE transit parameters on ports, follow these
steps.
1. Configure FCoE.
FCoE configuration:
copy flash:/ CONFIG_TEMPLATE/ FCoE_DCB_Config running-config
The configuration files are stored in the flash memory in the CONFIG_TEMPLATE file.
NOTE: DCB/DCBx is enabled when either of these configurations is applied.
2. Save the configuration on the switch.
EXEC Privilege mode.
write memory
3. Reload the switch to enable the configuration.
EXEC Privilege mode.
reload
After the switch is reloaded, DCB/DCBx is enabled.
4. Enable the FCoE transit feature on a switch.
CONFIGURATION mode.
feature fip-snooping
5. Enable FIP snooping on all VLANs or on a specified VLAN.
CONFIGURATION mode or VLAN INTERFACE mode.
fip-snooping enable
6. Configure the port for bridge-to-FCF links.
INTERFACE mode or CONFIGURATION mode
fip-snooping port-mode fcf
NOTE: To disable the FCoE transit feature or FIP snooping on VLANs, use the no version of a
command; for example, no feature fip-snooping or no fip-snooping enable.

Displaying FIP Snooping Information

Use the following show commands to display information on FIP snooping, .
Table 24. Displaying FIP Snooping Information
Command
show fip-snooping sessions [interface
vlan vlan-id]
FCoE Transit
Output
Displays information on FIP-snooped sessions on
all VLANs or a specified VLAN, including the ENode
349