Fiery 750DP - Phaser Color Laser Printer Administration Manual page 97

4
4-4 Administering the Fiery SI
After this Setup screen:
Enable AppleTalk
(AppleTalk Setup)
Network Setup, after choosing
Parallel Port Setup
Maximum Frame Size
(Token Ring Setup)
Select File Server From List
Enter First Letters
of Server Name
View Server List,
Edit Connection
Add File Server
Network Setup messages
This message:
No AppleTalk zone found.
Parallel (Input) must be
enabled in Server Setup.
Token Ring hardware
not installed or
not functioning.
Initialization failed.
Check all connections.
No NetWare file
server found.
File server name not found.
Try again?
No file server is selected.
All connections used.
Remove server?
Means:
The Ethernet network cable is not attached to the connec-
tor on the Fiery SI. If your AppleTalk network has zones,
and you want to specify a zone for the Fiery SI, you must
connect the network cable to the Fiery SI before perform-
ing AppleTalk Setup.
Also could mean that the AppleTalk network doesn't have
zones. Zones are not required for printing to the Fiery SI.
Press OK to continue.
Before you can configure your parallel port settings, you
must enable the parallel port in Server Setup.
Choose Exit Network Setup, and then choose Server Setup.
Fiery SI queries the Token Ring hardware. Error indicates
that some components are not installed, are not installed
correctly, or not installed in the correct device. An unsup-
ported Token Ring board may be in use. Check with your
authorized service/support center.
Fiery SI is unable to configure and use the token ring hard-
ware. Check with your authorized service/support center.
No file server was found when Fiery SI queried the network
to create a list of supported servers or a list of all servers.
Check cable connections and make sure the NetWare server
is turned on.
No file server with those letters was found when Fiery SI
queried the network. Check the name of the NetWare file
server, and check cable connections to make sure the Net-
Ware server is turned on.
No file server has been added in Network Setup.
You have added the maximum number of NetWare file
servers, which is eight for Ethernet plus eight for token
ring.