Fiery 750DP - Phaser Color Laser Printer Administration Manual page 57

2
2-33 Network Setup options
Select Target
Copier Target/SWOP/EuroScale/DIC/Linear/User-defined [Copier Target]
Specify the goal of this calibration by choosing a calibration target from a list of targets
on the Fiery SI hard disk. The list includes targets provided with the color server and
targets previously saved from the Fiery XJ Print Calibrator utility. The provided targets
include one based on color measurements of your particular copier or printer, targets
based on press standards, and a target to linearize your output.
Print Measurement Page
Yes/No [Yes]
Choose this option to print a page of known color data for measurement. You are noti-
fied that the copier is printing a measurement page without calibration.
If you selected
color swatches that you feed through the X-Rite densitometer. If you selected
glass , it prints a page of graduated colors that you place on the copier glass.
Measure Page
Yes/No [Yes]
Select to measure the colors on the measurement page.
Yes
The densitometer configures itself for reading the swatches on the measurement page.
You are prompted to position the cyan strip for measurement. The configuration pro-
cess takes up to 15 seconds and is repeated before reading each strip. The densitometer
feeds the paper through and collects the cyan measurements. When it has processed
the cyan measurements, you are prompted to insert the magenta, yellow and black
strips in turn.
If you previously selected
position the page on the copier and press OK.
If you select
played.
Print Comparison Page
Yes/No [Yes]
Specify if you want the Fiery SI to print a page with two versions of a test image,
Yes
one using a calibration based on your most recent measurements and the selected tar-
get, and one with no calibration.
as the
Densitometer Calibration Method,
Copier glass as the
No , measurement is skipped and the
the Fiery SI prints a page of
Calibration Method , you are prompted to
Print Comparison Page
Copier
option is dis-