About This Manual; Conventions Used In Fiery Si Manuals - Fiery 750DP - Phaser Color Laser Printer Administration Manual

xii Introduction

About this manual

You'll find the following information in this manual:
• Chapter 1 illustrates the supported network configurations and shows the network
connectors on the Fiery SI.
• Chapter 2 describes configuring the Fiery SI from its Control Panel.
• Chapter 3 offers guidelines for setting up Windows network servers and UNIX sys-
tems for printing to the Fiery SI.
• Chapter 4 summarizes some administrative features of Fiery SI software that are
available for the three major platforms, and offers some troubleshooting hints.
• Appendix A describes the Token Ring option.
Administrator features described in other manuals are summarized on page 4-1.

Conventions used in Fiery SI manuals

Actions you should perform are shown as numbered steps in bold-faced type, followed
by a brief explanation if needed. For example:
1. Choose Options in the Print dialog box.
Special options for your printer are available if you have installed the PostScript Level 2
driver and the PPD for your printer.
A special font indicates text you should type or keys you should press. For example:
<Tab> indicates that you should press the Tab key.
• At the NetWare 4.x drive prompt, type:
rconsole
The special font is also used to highlight options that appear in Fiery SI setup menus.
For example:
This option appears only if is set to
Enable Parallel Port
.
Yes