Parallel Port Setup Options - Fiery 750DP - Phaser Color Laser Printer Administration Manual

2
2-20 Setting up the Fiery SI
Network Setup
Parallel Port Setup

Parallel Port Setup options

Parallel port printing is enabled in Server Setup; port setup is completed in Network
Setup. You must have set the Server Setup Parallel Port option to
order to print to the parallel port and enter the Parallel Port Setup options.
Enable Parallel Port
No/Yes [No]
Select if you want to print through the parallel port. You can connect a single PC
Yes
compatible to the parallel port and print directly to the Fiery SI.
Port Timeout in Seconds
5-60 [5]
This option appears only if
how long the Fiery SI waits without receiving data from the parallel port before decid-
ing that the current job is complete. Until the timeout, the Fiery SI cannot receive new
jobs through the parallel port, but it can continue to receive network print jobs.
Ignore EOF Character
Yes/No [Yes]
This option appears only if
the Fiery SI should ignore end-of-file (EOF) messages in a file. This option must be set
to Yes to print PostScript files in binary format (not ASCII); under normal circum-
stances, it should be set to
allel port timeout value to determine when the end of the file has been reached.
When you have configured the parallel port options, choose another network type and
protocol, or choose Exit Network Setup and proceed to Printer Setup.
is set to
Enable Parallel Port
is set to
Enable Parallel Port
No . When this option is set to
in
Enabled (Input)
. Your setting determines
Yes
. This option specifies that
Yes
Yes , the Fiery SI uses the par-