Fiery 750DP - Phaser Color Laser Printer Administration Manual page 28

2
2-4 Setting up the Fiery SI
4. At the startup message, press any button.
For software
update or setup,
press any key.
5. Choose Run Setup to access all setup menus.
Run Setup
Install Software
Format Disk
Start Up
6. Press the line selection button to choose a Setup menu or command.
Exit Setup
Server Setup
Network Setup
Printer Setup
Setup
7. Choose setups in the same order as they appear in the menu: Server Setup, Network
Job Log Setup
Calibration
Change Password
Clear Server
Setup
T
O ACCESS
1. Make sure the Fiery SI is connected to the copier/printer and connected to the network
2. Turn on the Fiery SI.
3. At the startup message, press any button.
4. Continue with step 5 from the previous procedure.
The Start Up screen is displayed.
The Install Software and Format Disk commands are for service technicians.
Press the down arrow to view the second screen of the main Setup menu.
Setup, Printer Setup, and then Job Log Setup.
The sequence is important for first-time setup.
Later, just go directly to the menu you want to change. However, if you make
changes in Network Setup, you may need to change some settings in Printer Setup
as well.
If you make changes in Server, Network, or Printer Setup, you'll need to
NOTE:
update the system configuration by opening and saving the other setups even if
you haven't changed any other settings.
S F SI
ETUP WHEN THE IERY
you will use.
The startup diagnostics are performed.
Review the settings described in this chapter. For more information on calibration, and
on Control Panel screens other than those in the Setup, see the User Guide.
:
IS OFF