Fiery 750DP - Phaser Color Laser Printer Administration Manual page 36

2
2-12 Setting up the Fiery SI
Choose the next network type and protocol, or choose Exit Network Setup and pro-
ceed to Printer Setup.
Network Setup
Ethernet Setup
TCP/IP Setup
Enable TCP/IP
Yes/No [No]
Select
NOTE:
enabling TCP/IP here also enables you to use Fiery SI utilities from Windows NT
workstations using TCP/IP protocols. At the same time, enabling TCP/IP lets you use
Fiery SI utilities from Windows 95 computers using IPX/SPX protocols.
IP Address
[127.0.0.1]
Enter the Fiery SI IP address, for printing with TCP/IP. The Fiery SI is shipped with
an invalid IP address. If you plan to print with TCP/IP, you must first assign the
Fiery SI a unique, valid IP address. For information about setting up printing with
TCP/IP, see Chapter 3.
Subnet Mask
[255.255.255.0]
This option lets you modify the subnet mask for printing with TCP/IP. If you notice
that some, but not all, users can print to the Fiery SI using TCP/IP, you may need to
set the subnet mask. If you did not set the IP address for the Fiery SI, the subnet mask
is set to 255.255.255.0 by default. If you set the IP address and you need to set the
subnet mask, enter one of the following values:
if you have a TCP/IP network connected to the Fiery SI.
Yes
If you are using TCP/IP for printing from Windows NT workstations,
• —If the IP address starts with a number less than 128.
255.0.0.0
• —If the IP address starts with a number between 128 and 191.
255.255.0.0
• 255.255.255.0 —If the IP address starts with a number that is greater than 191.