Configuring A Windows Nt Server To Support The Fiery Si; Loading The Tcp/Ip Network Protocol - Fiery 750DP - Phaser Color Laser Printer Administration Manual

3
3-18 Setting up network servers
• Each server and workstation running Fiery SI remote utilities with TCP/IP needs the
TCP/IP protocol, utility software, the NET_WSCK.DLL file and a properly configured
NET_WSCK.INI file.
Configuring a Windows NT server to support
the Fiery SI
To configure a Windows NT server to communicate with the Fiery SI, follow these
general steps. More detail is provided in subsequent sections.
• Load the TCP/IP network protocol (see the next section).
• Enter the host name of the Fiery SI in the host database used by your system (see
page 3-20).
• On the Fiery SI Control Panel, perform Fiery SI Server Setup (see page 2-8), Net-
work Setup (page 2-10), and Printer Setup (page 2-23).
• Create a printer for each Fiery SI queue, installing the PostScript printer driver on
the Windows NT server, and (optionally) sharing the printer on the network (see
page 3-22).
• Enter the host name and internal name of the Fiery SI in the printer connection.
• Install the Fiery SI utilities and edit the NET_WSCK.INI file (see Getting Started
and page 3-25).

Loading the TCP/IP network protocol

If the TCP/IP protocol has not yet been installed on the Windows NT server, use the
procedure in this section.
For this installation, you will need:
• Your Windows NT installation disks
• The IP address of the Windows NT server
• The IP address of the Fiery SI (see page 3-28)
• The internal name of the remote printer (see page 3-29)