Configuring A Netware Server For Printing - Fiery 750DP - Phaser Color Laser Printer Administration Manual

3
3-4 Setting up network servers
Configuring a NetWare server for printing
The following sections explain how to set up a NetWare file server so that networked
users can print to the Fiery SI from their workstations, and the Fiery SI can obtain
print jobs from the NetWare server.
You can route all Fiery SI print jobs through the same NetWare file server, or you can
configure more than one file server to handle Fiery SI jobs. For Ethernet or token ring,
each Fiery SI connection requires a separate NetWare file server on which a print server
and print queue have been configured.
For each NetWare file server that you configure, follow these general steps. More detail
is provided in subsequent sections.
1. Make sure the server is connected to a functioning IPX network.
2. Log in as the Supervisor on a PC connected to the NetWare file server.
3. For NetWare 4.x installations only, you'll set the bindery context (see page 3-6).
4. Set up a new print server and print queue (see page 3-9).
5. At the Fiery SI Control Panel, in Network Setup, choose Ethernet Setup and IPX (Nov-
ell) Setup. Enable IPX (Novell), add support for the NetWare file server and the new
print server you configured, and select a poll interval (see page 2-14).
6. In Printer Setup, select the color server connection (Direct, Print queue, or Hold
queue) for the print server you created (see page 2-24).