Displaying System Information; Displaying Versions System Information; Shutting Down The System - HP 6100 User Manual

Displaying system information

NOTE: The purpose of this information is to assist the HP-authorized service representative when
servicing your system.
The system information displays show the system configuration, including the XCS version, the OCP
firmware and application programming interface (API) versions, and the enclosure address bus
programmable integrated circuit (PIC) configuration. You can only view, not change, this information.

Displaying versions system information

When you press
the:
OCP firmware version
Controller version
XCS version
NOTE: The terms PPC, Sprite, Glue, SDC, CBIC, and Atlantis are for development purposes and
have no significance for normal operation.
NOTE: When viewing the software or firmware version information, pressing
Versions Menu tree.
To display System Information:
1. The default display alternates between the Storage System Name display and the World Wide
Name display.
Press any push-button to display the Storage System Menu Tree.
2. Press
submenu items.

Shutting down the system

CAUTION:
You can use the Shutdown System function to implement the shutdown methods listed below. These
shutdown methods are explained in
Shutting down the controller (see
Restarting the system (see
Uninitializing the system (see
To ensure that you do not mistakenly activate a shutdown procedure, the default state is always
NO, indicating do not implement this procedure. As a safeguard, implementing any shutdown
method requires you to complete at least two actions.
, the active display is Versions. From the Versions display you can determine
until the desired Versions Menu option appears, and then press
To power off the system for more than 96 hours, use HP Command View EVA.
"Restarting the system" (page
"Uninitializing the system" (page
Table 21 (page 54).
"Shutting the controller down" (page
displays the
or
54)).
54)).
55)).
HSV controllers
to move to
53