Removing and Installing the Front Bezel
Removing the Bezel Assembly (Pedestal Only)
Caution: Do not rotate the bezel assembly more than 40 degrees or you will damage the bezel
assembly.
Note: The bezel assembly consists of two components, a front door and a sub-bezel. The system
was sent to you with the bezel key attached to the back of the bezel.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see
page
4. Release the two plastic tabs on the left side of the bezel assembly to disengage the
tabs. See letter "A" in the following figure.
5. Rotate the bezel assembly no more than 40 degrees outward. See letter "B" in the
figure.
6. At a 40-degree angle, push the bezel assembly away from the chassis. See letter
"C". If the bezel assembly does not immediately disconnect from the chassis, tap
the left-hand side of the bezel assembly to disengage the bezel hooks on the right-
hand side of the chassis.
26
24.
Figure 14. Removing the Front Bezel
"Removing the Chassis Cover" on
A
C
A
B
AF000557
Intel® Server System SC5400RA User's Guide