Removing A Slimline Usb Floppy / Cd-Rom / Dvd-Rom Combo Drive - Intel SC5400RA - Server System - 0 MB RAM User Manual

Removing a Slimline USB Floppy / CD-ROM / DVD-ROM
Combo Drive
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see
page
4. Remove the front bezel if it is installed. For instructions, see
Installing the Front Bezel" on page
5. Disconnect the power and data cables to the slimline combo drive assembly.
6. Remove the combo drive/slide assembly from the server system by pressing in on
the slide release latches. See letter "A" in the following figure.
7. Remove the slides from the slimline combo drive tray by pulling the slides away
from the tray. See letter "B". A gentle pull should release the slide from the side
dimple on the drive tray.
Figure 54. Removing Slimline DVD-ROM / CD-ROM Drive Assembly from
Intel® Server System SC5400RA User's Guide
24.
A
Upper Device Bay
"Removing the Chassis Cover" on
26.
A
B
"Removing and
B
AF000575
49