Table of Contents
Advertisement
9. Install the front bezel. For instructions, see
Bezel" on page
10. Install the chassis cover. For instructions, see
page
11. Plug all peripheral devices and the AC power cable into the server.
12. Power up the server.
Installing and Removing PCI Add-in Card(s)
Installing PCI Add-in Card(s)
Note: You may want to install an operating system before installing add-in cards.
Do not overload the server board by installing add-in boards that draw excessive current.
Add-in boards can be extremely sensitive to ESD and always require careful handling.
After removing the board from its protective wrapper, place it component side up on a
grounded, static-free surface. Do not slide the board over any surface.
When removing a full-length add-in card, you must pull back on the latch on the plastic
card guide at the front of the chassis to release the card from the card guide.
1. Observe the safety and ESD precautions in
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the AC power cord from the server.
4. Remove the chassis cover. For instructions, see
page
5. Remove the front bezel if it is installed. For instructions, see
Installing the Front Bezel" on page
6. Press in on the two plastic tabs to release the PCI add-in card retainer from the
server system. See letter "A" in the following figure.
7. Open the back panel PCI add-in card retention device by pulling it open from the
inside of the system. See letter "B".
8. If a PCI slot cover is installed, remove it by pushing the cover out from the inside of
the system. See letter "C".
54
26.
25.
24.
"Removing and Installing the Front
"Installing the Chassis Cover" on
"Safety Information" on page
"Removing the Chassis Cover" on
26.
Intel® Server System SC5400RA User's Guide
129.
"Removing and
Advertisement
Table of Contents
