Removing Pci Add-In Card(S) - Intel SC5400RA - Server System - 0 MB RAM User Manual

Removing PCI Add-in Card(s)

Caution: When removing a full-length add-in card, you must pull back the latch on the plastic card
guide at the front of the server system to release the card from the card guide.
1. Observe the safety and ESD precautions in
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the AC power cord from the server.
4. Remove the chassis cover. For instructions, see
page
5. Remove the front bezel if it is installed. For instructions, see
Installing the Front Bezel" on page
6. Remove any cables attached to the add-in card, if necessary.
7. Press in on the two plastic tabs to release the PCI add-in card retainer from the
server system. See letter "A" in the following figure.
8. Open the back panel PCI add-in card retention device by pulling it open from the
inside of the system. See letter "B".
58
24.
"Safety Information" on page
"Removing the Chassis Cover" on
26.
Intel® Server System SC5400RA User's Guide
129.
"Removing and