Table of Contents
Advertisement
15. Line up the screw holes on the left and right sides of the slimline floppy drive with
the corresponding holes in the drive cage. See letter "A" in the following figure.
The front of the slimline floppy drive will extend slightly out from the front of the
drive cage.
16. Use four screws in the bag labeled "FDU" that came with your slimline drive kit to
attach the drive to the drive cage (two screws on each side). Do not completely
tighten these screws until the CD-ROM / DVD-ROM drive is inserted into the drive
cage.
17. Turn the drive cage so that the metal flange at the side of the drive extends to the
right.
18. Lay the slimline CD-ROM drive or the slimline DVD-ROM drive in the drive cage,
with the front of the drive facing you. The slimline CD-ROM / DVD-ROM drive
lies on top of the slimline floppy drive.
19. Insert the backplane connector into the drive connector. See letter "A" in the
following figure.
20. Use two screws from the bag labeled "A" to secure backplane to slimline CD-ROM
/ DVD-ROM drive. See letter "B" in the figure below.
Figure 45. Attaching Backplane to Slimline CD-ROM / DVD-ROM Drive
44
A
Figure 44. Securing Slimline Floppy Drive to Drive Cage
B
A
AF000487
A
Intel® Server System SC5400RA User's Guide
AF000490
Advertisement
Table of Contents
