Table of Contents
Advertisement
7. Reach in through the memory riser cage to disconnect the two power cables from
the server board. If necessary, clip the wire tie that holds the two cables together.
Use caution so you do not cut any of the cables.
8. Install DIMMs, if necessary. For instructions, see
page
9. Seat the memory risers in the memory cage, pressing down firmly to seat the cards
into the server board sockets.
10. Close the door on the memory board cage and tighten the thumscrew to secure the
door.
11. Install the Intel
necessary. For instructions, see
NIC" on page
12. Install any necessary PCI add-in cards. For instructions, see
Card(s)" on page
13. Connect all remaining power and data cables to the server board. For connection
locations, see
Routing to Fixed Drives" on page 113
on page
14. Install the processor air duct. For instructions, see
Duct" on page
15. Install the chassis cover. For instructions, see
page
16. Plug all peripheral devices and the AC power cable into the server.
17. Power up the server.
Intel® Server System SC5400RA User's Guide
60.
®
Remote Management Module and the Intel
79.
54.
Figure 8 on page
114.
69. Use caution to make sure you do not pinch any cables.
25.
"Installing FBDIMMs" on
®
"Installing the Intel
RMM and the Intel
12. Route the cables as shown in
and
"Data Cable Routing to Fixed Drives"
"Installing the Processor Air
"Installing the Chassis Cover" on
®
RMM NIC if
®
RMM
"Installing PCI Add-in
"Power Cable
103
Advertisement
Table of Contents
