Clearing The Cmos; Figure 112. Cmos Clear Jumper In The Clear Cmos Position - Intel SC5400RA - Server System - 0 MB RAM User Manual

Clearing the CMOS

If you are not able to access the BIOS setup screens, the CMOS Clear jumper will need to
be used to reset the configuration RAM.
1. Power down the system. Leave the AC power cord connected.
2. Remove the chassis cover. For instrucstions, see
page
3. Locate the CMOS Clr jumper block at board position J1D1. See
4. Move the jumper from the normal operation position, covering pins 1 and 2, to the
CMOS Clear position, covering pins 2 and 3, as shown by the diagram.
CMOS CLR
2
3
J1D1
5. Wait 10 seconds.
6. Move the CMOS Clear jumper back to the original position, covering pins 1 and 2.
7. Install the chassis cover. For instructions, see
page
8. Power up the server system.
112
24.
Default
Clear
CMOS

Figure 112. CMOS Clear Jumper in the Clear CMOS Position

25.
"Removing the Chassis Cover" on
"Installing the Chassis Cover" on
Intel® Server System SC5400RA User's Guide
Figure 112.
AF001428