Removing A Dvd-Rom Or Cd-Rom Drive; Figure 58. Removing Dvd-Rom / Cd-Rom Drive Assembly From Upper Device Bay; Figure 59. Reinserting Empty Emi Shield/Slide Assembly - Intel SC5400RA - Server System - 0 MB RAM User Manual

Removing a DVD-ROM or CD-ROM Drive

1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see
page
4. Remove the front bezel if it is installed. For instructions, see
Installing the Front Bezel" on page
5. Disconnect the power and data cables to the DVD-ROM / CD-ROM drive.
6. Remove the DVD-ROM / CD-ROM assembly from the server system by pressing
in on the slide release latches. See letter "A" in the following figure.
7. Remove the slides from the DVD-ROM or CD-ROM drive by pulling the slides
away from the drive. See letter "B". A gentle pull should release the slide from the
side dimple on the drive.
Figure 58. Removing DVD-ROM / CD-ROM Drive Assembly from Upper
8. If not replacing with another drive, re-attach pair of slides to an EMI shield and re-
insert EMI shield/slide assembly into the server system for proper airflow. See the
following figure.
Intel® Server System SC5400RA User's Guide
24.
A

Figure 59. Reinserting Empty EMI Shield/Slide Assembly

"Removing the Chassis Cover" on
26.
A
B
Device Bay
"Removing and
B
AF000575
AF000605
53