Cable Routing; For Cable Connection Inside Node Tray; Removing And Installing The Front Bezel; Removing The Front Bezel - Intel H2312JFJR Service Manual

Hardware Installations and Upgrades

Cable Routing

®
The Intel Server System H2000JF family is a high density system, containing four identical
Compute Nodes inside. There are a few cables for chassis internal routing. Each Compute Node
is installed in tray and can be hot swapped without any impact to other nodes.
When you add or remove components from Compute Node tray, make sure your cables are routed
correctly before plugging in the node tray back to chassis. Use caution to make sure no cables or
wires are pinched and that the airflow from the fans is not blocked. Use the figures below to
determine the correct cable routing.

For cable connection inside Node tray:

Removing and Installing the Front Bezel

Removing the Front Bezel

If your system includes a front bezel, follow these steps to remove the front bezel:
1. Unlock the bezel if it is locked.
14
Yellow Lines: Fan cable connection
Red Line: Mother board power cable connection
Blue line: Fan control signal cable connection

Figure 18. Cable Routing inside Node tray

®
Intel Server System H2000JF Family Service Guide