Removing A Processor; Figure 79. Opening Processor Socket Lever; Figure 80. Opening Load Plate - Intel SC5400RA - Server System - 0 MB RAM User Manual

Removing a Processor

1. Observe the safety and ESD precautions in
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Remove the AC power cord from the server.
4. Remove the chassis cover. For instructions, see
page
5. Remove the air duct. For instructions, see
page
6. Remove the heatsink. For instructions, see
7. Push down on the lever attached to the processor socket. While holding the lever
down, pull it towards the center of the board to disengage the lever from the hook.
Fully open the lever. See
8. Push down on the rear tab of the load plate to swing the front of the load plate up
slightly. Fully open the load plate. See
74
24.
68.
Figure

Figure 79. Opening Processor Socket Lever

Figure 80. Opening Load Plate

"Safety Information" on page
"Removing the Chassis Cover" on
"Removing the Processor Air Duct" on
"Removing a Heatsink" on page
79.
AF000095
Figure 80.
Intel® Server System SC5400RA User's Guide
129.
77.
AF000415