Table of Contents
Advertisement
5. Install the chassis cover. For instructions, see
page
6. Reconnect the AC power and power up the server system.
The BIOS will boot to the previous BIOS until you either move the jumper again or until
you perform another BIOS update.
Clearing the Password
If the user or administrator password(s) is lost or forgotten, moving the password clear
jumper into the "clear" position clears both passwords. The password clear jumper must
be restored to its original position before a new password(s) can be set.
1. Power down the system. Leave the AC power cord connected.
2. Remove the chassis cover. For instrucstions, see
page
3. Locate the Password Clear jumper block at board position J1D2. See
4. Move the jumper from the normal operation position, covering pins 1 and 2, to the
Password Clear position, covering pins 2 and 3, as shown by the diagram.
110
25.
24.
"Installing the Chassis Cover" on
"Removing the Chassis Cover" on
Intel® Server System SC5400RA User's Guide
Figure
111.
Advertisement
Table of Contents
