Rmm Nic; Installing The Intel ® Rmm And The Intel ® Rmm Nic; Figure 85. Preparing System For Addition Of Intel ® Rmm Nic - Intel SC5400RA - Server System - 0 MB RAM User Manual

Installing and Removing the Intel
Management Module and the Intel
Installing the Intel
1. Observe the safety and ESD precautions in
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the AC power cord from the server.
4. Remove the chassis cover. For instructions, see
page
5. Open the back panel PCI add-in card retention device by pulling it open from the
inside of the system. See letter "B".
6. If a PCI slot cover is installed, remove it by pushing the cover out from the inside of
the system. See letter "C".
7. Install the Intel
"A" in the figure below.
8. Install the PCI bracket into the nearest available PCI slot opening. See letter "B" in
the figure below.
9. Attach the RMM NIC cable between the RMM NIC connector on the server board
and the connector on the RMM NIC. The server board connector is located between
PCI Express slots 3 and 4. See letter "C" in the figure.
Intel® Server System SC5400RA User's Guide
®
RMM and the Intel
24.
Figure 85. Preparing System for Addition of Intel
®
RMM NIC onto the PCI bracket that came with the kit. See letter
®
®

RMM NIC

"Safety Information" on page
"Removing the Chassis Cover" on
A
Remote
®
RMM NIC
129.
B
AF001527
®
RMM NIC
79