Table of Contents
Advertisement
3. Loosely screw in the captive screws on the heat sink corners in the order shown by
Figure 84. Do not fully tighten one screw before loosely attaching the others.
4. In the same order, gradually and equally tighten each captive screw until each is
firmly tightened. Do not fully tighten one screw at a time.
5. Install the processor air duct. For instructions, see
Duct" on page
6. Replace the chassis cover. For instructions, see
page
7. Reconnect the AC power cord.
Removing a Heatsink
Caution:
•
Do not attempt to operate your server system without a heatsink installed over each
installed processor. Doing so will cause your server to overheat and may cause
permanent damage.
•
The server system must be operated with both heat sinks installed, regardless of
whether one or two processors are installed.
Intel® Server System SC5400RA User's Guide
Figure 84. Installing a Heatsink
69.
25.
3
2
1
4
AF001488
"Installing the Processor Air
"Installing the Chassis Cover" on
77
Advertisement
Table of Contents
