Supplies; Figure 50: Installing The Router In The Rack - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide
Removing the T640 Router Installation Handle and Reinstalling the Power Supplies
92

Figure 50: Installing the Router in the Rack

NOTE: This illustration depicts the router being installed in a four-post rack.
For an illustration of the mounting hardware required for an open-frame rack,
see Figure 46 on page 83.
After you have installed the T640 router, remove the installation handle and reinstall
the two power supplies in the chassis, starting with the lower power supply (see
"Reinstalling a Power Supply" on page 111):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Loosen the captive screws on the installation handle completely, and remove the
2.
handle from the chassis.
Switch the circuit breakers on the power supply faceplate to the off position (
3.
Using both hands, slide the power supply into the chassis until you feel resistance.
4.
Twist the ejector handles at the upper corners of the power supply faceplate clockwise
5.
until they stop.
O
Copyright © 2010, Juniper Networks, Inc.
).