Replacing The M7I Routing Engine And Routing Engine Components; Replacing The M7I Routing Engine; Figure 38: Small Form-Factor Pluggable (Sfp) - Juniper M7I Hardware Manual

Related
Documentation

Replacing the M7i Routing Engine and Routing Engine Components

Replacing the M7i Routing Engine

Copyright © 2010, Juniper Networks, Inc.
Slide the SFP into the slot. If there is resistance, remove the SFP and flip it so that the
4.
connector faces the other direction.
Remove the rubber safety cap from the transceiver and the end of the cable, and
5.
insert the cable into the transceiver.
Arrange the cable in the cable management system to prevent the cable from
6.
dislodging or developing stress points. Secure the cable so that it is not supporting its
own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled
loop in the cable management system. Placing fasteners on the loop helps to maintain
its shape.
Verify that the status LEDs on the PIC faceplate indicate that the SFP is functioning
7.
correctly (there is an LED for each SFP port). For more information about the PIC
LEDs, see the M7i Multiservice Edge Router PIC Guide. You can also verify PIC functioning
by issuing the
show chassis fpc pic-status
FIC and FIC Cables and PICs and PIC Cables" on page 70.

Figure 38: Small Form-Factor Pluggable (SFP)

Connector
Locking pin
Preventing Electrostatic Discharge Damage to an M7i Router on page 128
M7i Chassis Description on page 6
M7i Router Physical Specifications on page 159
Replacing the M7i Routing Engine on page 97
Replacing the Routing Engine Interface Port Cables on page 99
Removing and Inserting the CompactFlash Card on page 100
Removing and Inserting SDRAM Modules on page 103
Removing and Inserting the PC Card on page 104
The Routing Engine is hot-pluggable, as described in "M7I Field-Replaceable Units (FRUs)"
on page 85. To replace a Routing Engine, perform the following procedures:
Removing an M7i Routing Engine on page 98
Installing the Routing Engine in a M7i Router on page 98
Chapter 15: Replacing M7i Hardware Components
command described in "Maintaining the M7i
97