CHAPTER 13
Maintaining M7i Router Hardware
Components
Routine Maintenance Procedures for the M7i Router
Purpose
Action
Related
Documentation
Maintaining the M7i CFEB and CFEB-E
Purpose
Action
Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to maintain hardware components installed in the router.
For information about returning a part to Juniper Networks for repair or replacement, see
"Contacting Customer Support and Returning M7i Hardware" on page 187.
Routine Maintenance Procedures for the M7i Router on page 69
Maintaining the M7i CFEB and CFEB-E on page 69
Maintaining the M7i FIC and FIC Cables and PICs and PIC Cables on page 70
Maintaining the M7i Routing Engine on page 72
Maintaining the M7i Power Supplies on page 72
Maintaining the M7i Cooling System on page 74
For optimum router performance, perform preventive maintenance procedures.
Inspect the installation site for moisture, loose wires or cables, and excessive dust.
Make sure that airflow is unobstructed around the router and into the air intake vents.
Check the status-reporting devices on the craft interface—System alarms and LEDs.
M7i Router Environmental Specifications on page 161
M7i Router Physical Specifications on page 159
Packing the M7i Router for Shipment on page 193
Overview of Troubleshooting Resources for the M7i Router on page 75
For optimum cooling, verify the condition of the CFEB.
Check the LEDs on the CFEB or CFEB-E faceplate. The green LED labeled
steadily on the CFEB or CFEB-E when it is functioning normally. For more information,
lights
OK
69