Unpacking The M7I Router; Tools And Parts Required To Unpack The M7I Router - Juniper M7I Hardware Manual

CHAPTER 6

Unpacking the M7i Router

Tools and Parts Required to Unpack the M7i Router

Related
Documentation

Unpacking the M7i Router

Copyright © 2010, Juniper Networks, Inc.
Tools and Parts Required to Unpack the M7i Router on page 41
Unpacking the M7i Router on page 41
Verifying the M7i Router Parts Received on page 42
To unpack the router and prepare for installation, you need the following tools:
Phillips (+) screwdriver, number 2
1/2-in. or 13-mm open-end or socket wrench to remove bracket bolts from the shipping
pallet
Blank panels to cover any slots not occupied by a component
M7i Router Description on page 3
M7i Chassis Description on page 6
M7i Chassis Lifting Guidelines on page 131
The router is shipped in a cardboard carton, secured with foam packing material. The
carton also contains an accessory box and the M7i Internet Router Installation Quick
Start.
NOTE: The router is maximally protected inside the shipping carton. Do not
unpack it until you are ready to begin installation.
To unpack the router, perform these steps (see Figure 24 on page 42):
Move the shipping carton to a staging area as close to the installation site as possible,
1.
but where you have enough room to remove the system components.
Position the carton so that the arrows are pointing up.
2.
41