Related
Documentation
Replacing the Routing Engine Interface Port Cables
Copyright © 2010, Juniper Networks, Inc.
Tighten the thumbscrews at each end of the Routing Engine.
4.
You can verify correct Routing Engine functioning by issuing the
5.
show chassis routing-engine
Engine" on page 72.
Figure 40: Installing the Routing Engine
Preventing Electrostatic Discharge Damage to an M7i Router on page 128
M7i Chassis Description on page 6
M7i Routing Engine Description on page 18
Maintaining the M7i Routing Engine on page 72
The Routing Engine is located on the front of the router, as shown in Figure 1 on page 6.
It houses the Routing Engine interface ports, which accept connections to external
management devices.
To replace the cables connecting to the Routing Engine interface ports, perform the
following procedures:
Replacing the Management Ethernet Cable on page 99
Replacing the Console or Auxiliary Cable on page 100
Replacing the Management Ethernet Cable
To replace the management Ethernet cable:
Press the tab on the connector on the management Ethernet cable and pull the
1.
connector straight out of the port. Figure 41 on page 99 shows the connector.
Disconnect the cable from the network device.
2.
Plug one end of the replacement Ethernet cable into the
3.
on page 100).
Plug the other end of the cable into the network device.
4.
Figure 41: Routing Engine Ethernet Cable Connector
Chapter 15: Replacing M7i Hardware Components
command, described in "Maintaining the M7i Routing
port (see Figure 42
MGMT
99