Installing A Dc Power Supply; Figure 52: Removing A Dc Power Supply - Juniper M7I Hardware Manual

Copyright © 2010, Juniper Networks, Inc.

Figure 52: Removing a DC Power Supply

Installing a DC Power Supply

To install a DC power supply (see Figure 53 on page 114 and Figure 54 on page 115):
Verify that there is no power flowing to the power supply from the external power
1.
source, so that the voltage across the leads of the power cables is 0 V. Ensure that
there is no chance that the cable leads might become active during the procedure.
Verify that the power switch for the power supply (located on the power supply
2.
faceplate) is in the
OFF
Verify that the grounding cable is attached to the chassis and properly connected to
3.
an earth ground.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
4.
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
Place one hand under the power supply and grasp the handle on the faceplate with
5.
the other hand. Slide the power supply into the chassis until it contacts the midplane.
Starting with the bottom screw, tighten (but do not overtighten) the thumbscrews
6.
at each corner of the power supply faceplate.
Verify that a licensed electrician has attached a listed power cable lug to each power
7.
source cable.
Loop the power cables through the hook located on the faceplate to the right of the
8.
field-wiring terminals.
Depending on the type of power cable lugs used, loosen or remove the screws on the
9.
field-wiring terminals.
Insert the power cable lugs into the appropriate field-wiring terminals. Using a number
10.
1 Phillips screwdriver, turn the screw on each field-wiring terminal clockwise to secure
the power cable lug. Apply between 8 lb-in. (.9 Nm) and 9 lb-in. (1.02 Nm) of torque
to each screw.
Insert the positive (+) source cable into the return terminal, which is labeled
a.
Chapter 15: Replacing M7i Hardware Components
( ) position.
O
.
RTN
113