Installing A Power Supply Module; Figure 16. Removing A Power Supply Module - Intel SSR212CC User Manual

Installing a Power Supply Module

Caution: Before performing any maintenance on the system, back up the data. Follow the
instructions in the operating system manual for shutting down the system.
Warning: This procedure should be performed by Service Personnel Only.
Warning: Do not remove the covers from a power supply module. Danger of electric shock exists
inside. Return the power supply module to your supplier for repair.
Caution: Handle the power supply module carefully and avoid damaging the connector pins. Do
not install the power supply module if any pins appear to be bent.
Important: If only one power supply module is to be installed in the storage system, it must be
installed in the lefthand slot with the top AC input socket used for connection to the power
source. A blanking plate must be fitted to cover the empty righthand slot and the unused
(lower) AC input socket. Operation of the storage system with ANY modules and.or
blanking plates missing will disrupt the airflow and the drives will not receive sufficient
cooling. It is ESSENTIAL that all apertures are filled before operating the unit.
To install a replacement power supply module or to add a redundant power supply
module, use the following instructions:
1. Observe all safety and ESD precautions listed in
2. (For replacing a power supply module only) Remove the failed power supply module.
For instructions, see
Intel® Storage System SSR212CC User Guide

Figure 16. Removing a Power Supply Module

"Removing a Power Supply Module" on page
Hardware Installations and Upgrades
B
TP01846
Appendix D, "Safety Information".
18.
19