Operation; Before You Begin; Power On; Power Supply Module Led - Intel SSR212CC User Manual

3

Operation

Before You Begin

Before powering up the enclosure please ensure that all the modules are firmly seated in
their correct bays.

Power On

Caution: Do not operate the subsystem until the ambient temperature is within the specified
operating range. If the drives have been recently installed, ensure they have had sufficient
time to acclimatize before operating them.
Note: Please refer to
related fault conditions.
Perform the following to Power On the storage system:
1. Apply AC mains power to the storage system. Press the Power button on the back of
the system.
2. All LEDs on the Front Panel should be lit (green) when the storage system power is
activated (and the disk drive motors should start). The system may take up to 15
minutes to boot up.
Important: If mains power is lost for any reason, on restoration of power, the storage system will re-
start automatically.

Power Supply Module LED

The power supply module provides a single external bi-color LED to indicate the status of
the power supply. When AC power is applied to the power supply module and standby
voltage is available, the LED will blink green. The LED will be solid on green to indicate
that all power outputs are available. The LED will be solid on amber to indicate that the
power supply has failed, there has been a shut down due to an over current or over
temperature condition, or there has been a predictive failure. Refer to the following table
for conditions of the power supply module LED.

Table 5. Power Supply Module LED Indicators

No AC power to all power supply modules
No AC power to this power supply module only
Intel® Storage System SSR212CC User Guide
"Front Panel LEDs" on page 104
Power Supply Condition
for details of the Front Panel LEDs and
Power Supply LED
OFF
Amber
103