Rear Panel Buttons
Table 7. Rear Panel Button Functions
Button
Power
Toggles the system power on/off.
Reset
Resets the system
Starting the Drives
Unless otherwise selected during installation, all drives in the enclosure should
automatically start their motors. If this does not occur then one of the following conditions
may exist:
•
There may be a power problem (an alarm and power fault indication would normally
be active).
•
If there is only one power supply module present, the drive motors will spin up in a
delayed sequence.
Disk Drives LEDs
Each drive carrier incorporates a green Drive Status LED and an amber Drive Fault LED.
Drive Status LED
Drive Fault LED
Power Down
To power down the storage system:
•
Refer to the documentation that came with your operating system for instructions on
how to shut down the system.
•
In the event of a system failure or hang condition that prevents you from powering
down the system via the Intel
Hold down the Power button for approximately 3 seconds
Remove AC mains at the power source.
Intel® Storage System SSR212CC User Guide
LED
OR
Definition
Definition
Flashes green as drive operates
Continuous amber light indicates a failure condition
®
Storage System Console, do the following:
Operation
105